Cedar รุ่น DID-4 ไขควงวัดแรงบิด,Digital Torque Screwdriver,Meas.range:0.020～4Nm.

Part number

DID-4

Measurement range

0.020 to 4 Nm

accuracy

±0.5% (0.499N・m or less ±0.003N・m)

display

LCD 4-digit digital display

Measurement direction

CW-CCW (right/left direction)

Measurement Mode

PP (Peak): Maintains the highest load value

TR (Track): The display changes depending on the load change.

PD (Peak Down): Holds the moment when the load goes from rising to falling

C (Real-time output): Load data is output and saved every 1/160 seconds

Upper and lower limit settings

Both upper and lower limits can be set within the measurement range. Up to 5 sets can be saved.

Pass/fail judgment function

You can check the pass/fail result within the set range (in PP mode).
The lamp lights up to confirm: GOOD (pass) - green NG (fail) - red

Maximum, minimum and average values

Displays the number of data points, maximum value, minimum value, and average value of memory data.

Data Memory

Measurement data: 800

Data Output

When outputting data in ASCII format (baud rate 19200) , a separate USB cable is required (USB mini-B type).

Auto Clear Time

The display will automatically be reset to zero in 0.1 to 3.0 seconds (0.5 second intervals)
Manual zero clear at 0.0 second setting

One Touch Zero

Zero adjustment can be performed with one touch from any measurement mode.

Setting the count number

1 to 99 counts (counts in the tightening direction)

power supply

Nickel-metal hydride battery 1.2v x 4 cells (800mAh)

Charging time/Usage time

Charging time: approx. 3 hours / 12 hours continuous use when fully charged

Auto Power Off

Leave it for 10 minutes and then turn it off

Bit fitting port

HEX6.35

weight

Approximately 400g

Accessories (1 each)

Bit + #1 #2
Bit holder
One-way bit holder
Dedicated charger (input AC 100V-230V 50/60Hz)
Inspection report, calibration certificate, traceability system diagram

option

When outputting data, a separate USB cable (mini B) is required.