PCE รุ่นTAT-10เครื่องวัดทดสอบการยึดเกาะวัสดุAdhesion Tester

Preparation for use

- Clean the surface of the measuring probe and the surface where you want to place the probe, for example, by using fine sand paper.

- Prepare the epoxy adhesive as instructed on the packaging and mix it thoroughly.

- If you use single-component super glue, open the tube.

- Apply the glue to the surface and place the measuring probe on the surface covered with glue, as described in more detail on the packaging.

- Use the cutter to slightly scratch the area around the measuring probe.

Operation

- Turn the top knob of the adhesion tester counter-clockwise to release the gripping mechanism and the spring.

- Now screw the adhesion tester (thread at the bottom) onto the measuring probe until the device reaches the surface to be tested.

- Turn the top knob clockwise until the measuring head is released from the test surface. You can read the tearing force from scale 1 or 2, depending on the measuring probe used.

- If the measuring probe has not been separated from the surface, turn the knob counter-clockwise to release the spring mechanism and remove the device from the measuring probe.

- Separate the measuring head from the surface, using a chisel and hammer.

- If the measuring probe has been separated from the surface, unscrew it from the device, using the wrench.

- Clean from the surface of the measuring probe any glue and paint residues or splinters.